for use only with our RestoMod Series wiring system, should your ignition switch become damaged or in need of replacement. NOTE: This switch is already included with our RestoMod Series wiring system.
TECH NOTES:
This ignition switch is already included in our RestoMod Series wiring system and does not need to be purchased separately.
However, if your switch becomes damaged or in need of replacement, this switch kit will service your RestoMod Series wiring system.
NOTE: This switch will NOT connect to a factory original harness, nor our Original Design Series (OEM-type) harness.
INCLUDES:
- Ignition Switch, this is the current switch included in our RestoMod Series wiring harness system
- Connector, required if you had purchased an early version RestoMod Series wiring harness system
- Terminals, included in the event a repair is necessary
- Instructions
- Spacer Nut
- Bezel/Retaining Nut
- Trim Ring
CONNECTS TO:
- RestoMod Series wiring harness system only.
NOTE: This switch will NOT connect to a factory original harness, nor our Original Design Series (OEM-type) harness.
Vehicle Fitment:
The Vehicle Fitment Guide is to be used as a general reference. The data has been provided by our suppliers and manufacturers and may contain errors or incorrect data. Always refer to a professional to verify correct fitment for your vehicle.
| Make |
Model |
Years |
| Chevrolet |
Corvette |
1953 - 1967 |
IMPORTANT: Electrical items are covered by a 30 day EXCHANGE ONLY WARRANTY. There are no returns or refunds on such items.
