Replaces GM Part #25007308
Used for vehicles with 40 - 45 teeth on the driven gear.
This is a direct replacement, with a brand new original Delco VSS and wire harness, which is fully plug and play with your factory chassis wire…
The Engine Coolant Temperature Sender monitors the engine temperature. The engine temperature signal is used by the engine control module to adjust the air/fuel mixture and ignition timing. Male oval connector
81-84 Located in Front…
This is a resistor that can be installed in line in your temp wire. It can be set to your engine temperature for gauge accuracy.
The number of degrees of engine temperature change on the dash gauge varies greatly with the values of the…
Stock Replacement
This stock replacement air conditioning pressure cycling switch is manufactured by GM or by one of its authorized suppliers for use as a factory replacement part. You will find the fit and function meet all GM…
Stock Replacement
This stock replacement manifold absolute pressure sensor is manufactured by GM or by one of its authorized suppliers for use as a factory replacement part. You will find the fit, finish and function meets all GM…
Stock Replacement
This stock replacement oil temperature sensor is manufactured by GM or by one of its authorized suppliers for use as a factory replacement part. You will find the fit, finish and function meets all GM…
Replacement Sensor
Black Wire Connector End
Solid Probe
1985-91 Located Under Plenum
1992-96 Located In Water Pump
For Computer Input
This Corvette replacement engine coolant temperature sensor has been…
Stock Replacement
This stock replacement throttle position sensor is manufactured by GM or by one of its authorized suppliers for use as a factory replacement part. You will find the fit and function meets all GM specifications.
…
Your 1985-91 MAT sensor's stock location is near a great deal of heat, causing loss of performance. Our MAT Sensor Relocating Kit moves the sensor to allow cooler ambient temperature readings. Requires drilling a 7/8" hole in the air…
When you run an LS engine, performance begins with the introduction of air into the intake manifold. MSD's new 90mm LS Throttle Body answers the need for a high quality throttle body with a mechanical throttle mechanism that bolts to most…
Replacement Sensor
1987-91 One Required Per Car
1992-93 Two Required Per Car
Did you know? Many people in our hobby refer to the exhaust oxygen sensor as a 02 sensor.
…