Suggested for drivers who want a stronger spark or who want to make sure it doesn't fail if the key is left "ON"
* The Ignitor II is not damaged if the ignition switch is left in the "ON" position when the engine is not running
* The Ignitor II can use low-resistance performance coils: 0.45-3.0 DC ohms (most coils are OK but not HEI Coils or E-Core Square Coils)
* The Ignitor II increases dwell at higher RPM to produce a better spark (but this dwell change doesn't affect timing)
* The Ignitor II used the magnet ring and therefore can require distributor removal if shims need to be added above the drive gear
* The Ignitor II draws more current than a stock ignition system. Bypassing the resistor or resistance wire isgenerally recommended (can require some rewiring)
Includes:
271090 Pertronix Ignitor II
302203 BB Flame Thrower Spark Plug Wires
301147 Flame Thrower II Black Coil
DISTRIBUTORS IGNITION COILS
Vehicle Fitment:
The Vehicle Fitment Guide is to be used as a general reference. The data has been provided by our suppliers and manufacturers and may contain errors or incorrect data. Always refer to a professional to verify correct fitment for your vehicle.
| Make |
Model |
Years |
| Chevrolet |
Corvette |
1965 - 1974 |
