This molded plastic grommet is an identical reproduction of original equipment and is designed to keep the accelerator cable from pulling through the pedal linkage. Sold per each, the grommet snaps into the accelerator pedal linkage and is…
This is an OER® reproduction of the bushings needed to install the accelerator rod support correctly. These bushings will eliminate excessive play in the gas pedal pad while promoting smoother, more even accelerator operation. Sold as a…
OER® reproduction of the original grommet and sleeve unit where the accelerator rod fits into linkage. This grommet often deteriorates due to engine heat or chemical spillage. Replacing the grommet will keep your throttle rod from…
OER® reproduction of the correct retainer used to hold the accelerator control cable. This retainer slips over the cable and clips into the hole on the accelerator pedal arm. Manufactured in injection molded plastic material as…
These Holley brackets provide for throttle cable and throttle return spring installation. They are just what you need to install your throttle cable the right way.
…
My Account
